Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[DJ24966]

I'm running Unreal 3.2.7 and after about 10 minutes, Anope just fails, and shuts down. i've searched, and have found nothing helpful here.

Can someone please give me an idea?

[zEkE]

[Note to admins, someone should make a sticky note for 'how to get support' since it gets requested a lot....I couldn't see it in an obvious fashion near the top...]

Have you run services in Debug mode?

Enable debug mode, run services until they crash, and post from the log. Even better (and probably in addition) if you're running on *nix, you can also provide the support staff with a backtrace using the instructions here: http://anope.info/wiki/Other:GDB

[Robin Burchell]

That notice is from Unreal, not Anope, and has something to do with the buffering of connections - it is likely that anope is sending more than Unreal can handle, but I don't remember specifics.

[casper1256]

SendQ en ReceiveQ perhaps?

[DJ24966]

Well either way, I was able to get it fixed. It's been running fine since last night.

[Charles Kingsley]

For the benefit of other users, what did you do to solve the problem?

[DJ24966]

Forgot to add the following to my Unreal config

Code: [Select]

ulines { services.yoursite.net; };