Hey Everyone,
I've been searching all over to no avail on how to get anope setup with ircd-hybrid. I have the latest package downloaded and installed inside the users home dir. I went through the example.conf file and set it up although I'm not sure what the default password is for the linking section. I am also not sure where exactly the file is supposed to go after you get done editing it. I then tried to run the service with the ./services command however after doing that it does nothing it just goes back to my command prompt. I check the processes for the services process and nothing so I'm kinda at a loss here I've been googling for the last 3 hours on how to get this sucker setup and I've also read through the wiki but the wiki is for version 1.8 and since I'm using 1.9 I'm not sure how accurate the wiki is for me. Thank you in advance for your assistance with this matter.