Anope IRC Services
Anope.org => General Chat => Topic started by: StormFury on June 11, 2007, 02:56:55 PM
-
Hey guys, great product here. Installs well and runs fine.
1 problem. Every time I join my channel #Hangout it does this.
[08:47::21] * Now talking in #Hangout
[08:47::21] * ChanServ sets mode: +nt
[08:47::21] * ChanServ changes topic to ''
[08:47::21] * ChanServ sets mode: -o StormFury
I have to /hop to do this
[08:47::28] * Attempting to rejoin channel #Hangout
[08:47::29] * Rejoined channel #Hangout
[08:47::29] * ChanServ sets mode: +nt
[08:47::29] * ChanServ changes topic to ''
[08:47::29] * ChanServ sets mode: +q StormFury
Any Ideas? Thanks.
[Edited on 11-6-2007 by StormFury]
[Edited on 11-6-2007 by StormFury]
-
I'm guessing you have NickServ AUTOOP options disabled for your nick. Make sure you identified to nickserv and try /NickServ SET autoop ON and see if it works or not..
-
Did that and it didn't work. It only happens in channel #Hangout
-
DROP the channel, register it again, and see if it still happens or not. If it still happens, your problem may be because of an incorrect u:lines or a module which can caused desynch. double check your ircd ulines and services.conf.
-
Do you identify before or AFTER joining the channel?
If after try uncommenting NSModeOnID in services.conf
-
un-commenting NSModeOnID now works.
Now talking in #Hangout
[14:32::36] * ChanServ sets mode: +nt
[14:32::36] * ChanServ changes topic to ''
[14:32::36] * ChanServ sets mode: -o StormFury
[14:32::36] * ChanServ sets mode: +qo StormFury StormFury
I tried a fresh install and have dropped and added the channel. I still get the same thing.
-
is it possible you have an auto identifier that identifies you as you join the channel
assuming that this happened when you rejoined the channel on connect