Hi...
I'm new around here...
I'm struggling to install and setup an ircd using Anope and need some help...
I've compiled and successfully installed and confgured UnrealIRCd 3.2.8.1.
Then i've installed and configured Anope 1.8.6. I've launched ./services in debug mode (./services -debug --nofork) and apparently everything went smoothly ok...
Then i've realised that there was a newer version of anope (1.9.5). So i downlaoded it, untar it, installed CMake 2.8.6 and then i've configured Anope 1.9.5 with CMake.
Now maybe my Debian Squeeze may be a little confused (or not) because of 2 versions of anope has been installed...
Please help me un-installing both anopes so that i start it all over again but just with anope 1.9.5 with CMake 2..6 versions installed...
How do i un-install anope 1.8.6 that has been configured just with ./Config && make && make install commands?
And how do i un-install anope 1.9.5 that was configured after CMake has been installed and been configured with ./Config && make && sudo make install commands???
Cheers