Anope IRC Services

Anope.org => Anope General => Topic started by: Herman on March 07, 2014, 11:56:38 AM

Title: Need to be operator to register channel
Post by: Herman on March 07, 2014, 11:56:38 AM
Unreal 3.2.10.2
Anope 1.8.8
irc.place2chat.com 6667 0r 6697

Hello, since a while i have this problem. When some one register their own channel sometimes (almost every time) there is this error.

Quote
You need to be a channel operator to register a channel.

Then when I (Owner) go to that room, see that person is @ operator I deop and op again and then they can register the channel. Then most of the time the mode ntr dont show up before I restart services. Then a lot of people need to identify again. After that its okay till the next channel registration. Can some one please help me with this? I am Dutch so I hope you understand my English.

Regards, Herman.
Title: Re: Need to be operator to register channel
Post by: katsklaw on March 07, 2014, 03:39:34 PM
Sounds like you have a desync somewhere. Try disabling the time sync feature in unreal and install NTP. Then restart your ircd and services.
Title: Re: Need to be operator to register channel
Post by: Herman on March 07, 2014, 07:08:23 PM
Hello Katsklaw,

thanks for your reply.
I run a linux vps where the unreal is running at. So I need to do as you said also on linux? Is there a place where I cab read how to do this all? I am not that good.

Regards, Herman.
Title: Re: Need to be operator to register channel
Post by: katsklaw on March 07, 2014, 08:09:01 PM
Hello Katsklaw,

thanks for your reply.
I run a linux vps where the unreal is running at. So I need to do as you said also on linux? Is there a place where I cab read how to do this all? I am not that good.

Regards, Herman.

Yes, both Unreal and Anope have excellent documentation that shipped with your copy. Just read the doc(s) directory.