I'm having a problem getting Anope 2.0.1 to link to Unreal 3.2.10.4 on the same machine. I upgraded from Anope 1.8.8 and attempted to link 2.0.1 to Unreal 3.2.10.1, but it did the same thing it is doing now with 2.0.1 and Unreal 3.2.10.4.
Everytime it attempts to connect I get this:
Unable to connect to uplink #1 (127.0.0.1:7000): Unable to bind to address: The system detected an invalid pointer address in attempting to use a pointer argument in a call.
It's not very helpful to figure out what went wrong and "using your old config as a reference" was a complete waste of time. There are new configuration options that weren't there, such as: userlen, hostlen, and chanlen, which were left as default since nothing in unreal has anything in the configuration talking about the length of those options. Yet, the configuration says "Set this to the maximum allowed object length on your network. Be sure to set this correctly, as setting this wrong can result in Services being disconnected from the network."
Upgrading to Anope 2.0.1 is such a damn nightmare when you check, double, check and then check it a third time and it doesn't work worth crap. So what do you need to look at to fix the uplink bullcrap so I can move on.
I never had any problems with Anope 1.8.8, so having to visit the forum just to get support for upgrading to Anope 2.0.1 is saying something about how complicated it is just to upgrade than it is to start all over and needs better documentation.