Anope IRC Services

Please login or register.

Login with username, password and session length
Advanced search  

News:

Pages: [1]   Go Down

Author Topic: howto change symbols from ~ & to ! *  (Read 13354 times)

0 Members and 1 Guest are viewing this topic.

New_kid

  • Guest
howto change symbols from ~ & to ! *
« on: December 13, 2008, 02:28:37 AM »

Hey out there

First sorry for my English, my native toungh is Danish..

I have a little problem with status symbols.. i like to change ~ & to ! *

I run unreal3.2.7 with Anope1.6.5.

It worked just fine with unreal3.2.3, but cant get it to go now, after upgrade of unreal.

Hope that someone can point my in the right direction.

Cheers and keep up the god work your all doing.

New_kid
Logged

Trystan Scott Lee

  • Contributor
  • *
  • Offline Offline
  • Gender: Male
  • Posts: 343
Re: howto change symbols from ~ & to ! *
« Reply #1 on: December 13, 2008, 03:16:36 AM »

This is an ircd question, has nothing to do with services
Logged
my God my tourniquet, return to me salvation

Jobe

  • Contributor
  • *
  • Offline Offline
  • Gender: Male
  • Posts: 1023
    • Anope IRC Services
Re: howto change symbols from ~ & to ! *
« Reply #2 on: December 13, 2008, 12:37:01 PM »

Not to mention using * in nick prefix is a bad idea, especially when you consider extended ban type ~c:[<prefix>]<channelmask>

If you used ~c:*#blah, does it mean channels ending in "#blah" (which is possible), or does it meant users in channel #blah, with * or above?
Logged
Your IP: ()
My IRC Status:

Come along and visit http://www.anopequotes.org/

New_kid

  • Guest
Re: howto change symbols from ~ & to ! *
« Reply #3 on: December 13, 2008, 03:33:03 PM »

Thx for your answer though, not pointing in any directions.

Only that is is a ircd question.. ill ./Config ircd the same way a before.

and i cant see the problem about ~& in ban type, im Admin ??

thx again, and merry christmas..

New_kid
Logged

Master

  • Anope User
  • Offline Offline
  • Posts: 56
Re: howto change symbols from ~ & to ! *
« Reply #4 on: December 29, 2008, 06:00:05 AM »

The IRCd decides how the users are prefixed, not Anope. In fact, it cannot even influence it.
Logged
Always believe Murphy's Law. If you don't, watch what happens.

Jobe

  • Contributor
  • *
  • Offline Offline
  • Gender: Male
  • Posts: 1023
    • Anope IRC Services
Re: howto change symbols from ~ & to ! *
« Reply #5 on: December 29, 2008, 11:27:51 AM »

The IRCd decides how the users are prefixed, not Anope. In fact, it cannot even influence it.

I accept you was just trying to help but the thread is nearly a month old and your point had already been made. So please do not drag up old threads unless you have something worthwhile to add that has NOT already been mentioned.
Logged
Your IP: ()
My IRC Status:

Come along and visit http://www.anopequotes.org/
Pages: [1]   Go Up