Anope IRC Services

Anope Development => Modules => Topic started by: Tom65789 on March 26, 2006, 12:28:45 PM

Title: [ Released ] os_chanmsg
Post by: Tom65789 on March 26, 2006, 12:28:45 PM

I Thank Rob & Trystan for their help and Rob for saying "<Rob> You Dummy, It should be Channel *c Not Channel *ci" :D and Trystan for Helping me Understanding it a whole lot easier :) but here it is:

http://www.area51designz.com/c/anope/os_chanmsg.c

This Module makes ChanServ sends a notice to EVERY
Registered Channel on the Network With the MSG you
Tell it too.

SYNTAX: /msg OperServ CHANMSG (TEXT)

Please Report Any problems you find :) or any Features i can try to improve it.

[Edited on 11-5-2006 by Tom65789]

Title:
Post by: Oberon on March 26, 2006, 05:40:43 PM

It looks very nice!

I'm going to try it i think :)

Title:
Post by: Tom65789 on May 11, 2006, 04:28:49 PM

ok its been a while but i just fixed a small memory leak which wasnt too bad but would be better without the leak.

download from the same place

Title:
Post by: dydo on May 15, 2006, 01:04:47 AM

this crashed my services :'(

Title:
Post by: Tom65789 on May 15, 2006, 07:39:12 AM

could you be a bit more specific. but /msg OperServ set debug on. do the CHANMSG command then paste the from where you do the command. but i think i already know what it was. could you re-download from the same link as i updated it again. but set your debug on before using the command.

[Edited on 15-5-2006 by Tom65789]