Anope Support > 1.8.x/1.7.x Support (Read Only)

logchan - can't use set command with operserv

(1/2) > >>

OssieB:
hi,
i got a question: how can i turn on the logchan with operserv?
i added the logchan in the services.conf but i cant use the /msg operserv set (command) at all.
gives this error:  *OperServ* Unknown command set. "/msg OperServ HELP" for help.
anyone who could help me get it fixed?

lavinpj1:
Sounds to me like the operserv modules are messed up. Make sure the OS_Modules is all on one line and you have the necessary modules in there.

Tom65789:
are you using: /msg OperServ set logchan on

and make sure you have got the Config set to a channel which i assume you have:


--- Code: ---
# LogChannel <channel> [OPTIONAL]
#
#     When defined, services will output log messages to this channel.
#     IMPORTANT: This can be a security risk so make certain this channel
#     is sufficiently protected from normal access.

LogChannel "#logchan"

--- End code ---

Trystan Scott Lee:
os_set must be loaded then /os set logchan on will work

OssieB:
thx for the help but i still cant get it to work
i double checked the services.conf and os_set is in the operserv modules line.
and the logchannel is also set.
but i cant seem to get the "/os set" command to work.
are there any flags i need to set extra on O-line to get it working, i tried services-admin and allmost all other modes?

*i just tried to manually load the os_set module with /os modload os_set but that wont work either, all other modules load fine with /os modload , even os_raw but there's something thats preventing me from loading os_set.
os_set is present in modules folder though

[Edited on 26-2-2006 by OssieB]

Navigation

[0] Message Index

[#] Next page