Anope IRC Services
Anope.org => Anope General => Topic started by: Herman on February 12, 2016, 03:37:47 PM
-
Hello,
I run Anope-2.0.2 and I have installed the module os_notinchan.cpp in the folder "third" but I can not load the module in IRC yet. Can some one please tell me what I need to do so I can load the module? Please when possible in simple english because english is not my home language.
Best regards, Herman.
-
From the anope 2.0.x wiki:
How to install a module
1 put the module source into modules/third/.
2 Run ./Config (again) to generate correct makefiles
3 Type: cd build
4 Type: make install
5 Update your config files in services/conf/
6 Issue a /msg operserv restart, or use /operserv modload <module_name> to load the new module.
In step 5, for this module you need to add the following in operserv.conf (or operserv section):
module {
name = "os_notinchan"
tshunreason = "Rejoin us when you are willing to join us publicly."
killreason = "Non-Channel kill"
akillreason = "Not-in-channel ban"
akillexpire = "7m"
idlechan = "#idle"
}
command { service = "OperServ"; name="NOTINCHAN"; command = "operserv/notinchan"; permission = "operserv/akill"; }
Az
-
Hello Azander,
thank you for your reply. This is what I don't understand. The module is located in /third/ . Then I log in but where do I have to do ./Configure? when I run it in /third/ this is what I get. -bash: ./Config: No such file or directory
Regards, Herman.
-
Run ./Config in the base anope folder, just like you did when you set up anope the first time.
Az
-
Hello Azander,
thank you verry much, its working now. 1 more question about this, i just klikt enter on every question during config. Does there are no changes made now in Anope?
Regards, Herman.
-
The only changes are the compile count, module, and the config to load the module. Nothing else is altered.
-
Thanks a lot for your help Azander.
Regards, Herman.