Anope IRC Services
Anope Support => 1.6.x (Read Only) => Topic started by: New_kid on December 13, 2008, 02:28:37 AM
-
Hey out there
First sorry for my English, my native toungh is Danish..
I have a little problem with status symbols.. i like to change ~ & to ! *
I run unreal3.2.7 with Anope1.6.5.
It worked just fine with unreal3.2.3, but cant get it to go now, after upgrade of unreal.
Hope that someone can point my in the right direction.
Cheers and keep up the god work your all doing.
New_kid
-
This is an ircd question, has nothing to do with services
-
Not to mention using * in nick prefix is a bad idea, especially when you consider extended ban type ~c:[<prefix>]<channelmask>
If you used ~c:*#blah, does it mean channels ending in "#blah" (which is possible), or does it meant users in channel #blah, with * or above?
-
Thx for your answer though, not pointing in any directions.
Only that is is a ircd question.. ill ./Config ircd the same way a before.
and i cant see the problem about ~& in ban type, im Admin ??
thx again, and merry christmas..
New_kid
-
The IRCd decides how the users are prefixed, not Anope. In fact, it cannot even influence it.
-
The IRCd decides how the users are prefixed, not Anope. In fact, it cannot even influence it.
I accept you was just trying to help but the thread is nearly a month old and your point had already been made. So please do not drag up old threads unless you have something worthwhile to add that has NOT already been mentioned.