Anope Development > Modules

[ Request ] NoExpire and additional mlock modes

(1/3) > >>

Spy:
Hello.
1. Under the "NoExpire" command i meant a OperServ command set either on a nick or on a channel to prevent them being dropped from databases with time.
2. Some modules might be added to the ircd adding pretty useful and desired channel modes. But when one tries to mlock the new mode(s), ChanServ refuses to do so stating that such mode is unknown to him. Is there a way to fix this?
Thanks in advance.

Dave Robson:
1.  /msg nickserv help saset  (assuming you have the saset module loaded)
2.  chanserv isnt told about these new modes added to the ircd, so it cant really try to keep them set.

Spy:
1. No. Not installed. Where to get it?
2. How to "tell" ChanServ of existing of new modes ?

[Edited on 20-2-2006 by Spy]

Dave Robson:
you already have it, it comes with anope.  Add it to your .config so it loads at start up, or /msg operserv modload ns_saset.

That would need a module to tell it about the modes added by the ircd module :)

Spy:
1. Hmm... Is it shipped with Anope 1.6.4? I really can`t find it ;(
2. Thanks. But is there some of those already done to use as a template? I`m no coder yet.

Navigation

[0] Message Index

[#] Next page