Anope IRC Services

Anope Support => 1.6.x (Read Only) => Topic started by: Movian on July 10, 2007, 02:07:26 PM

Title: Problems when assigning bot to channells
Post by: Movian on July 10, 2007, 02:07:26 PM
Hey i did a quick search and couldn't find a solution to this although i have found some possible causes. However i don't know enugh about the way anope / unrealircd works to fix them :S and wanderd if you guys could help

anope and unrealircd apear to be working fine. untill i assign a bot to a channell. At which point everything slowly grinds to a halt and i get the error message *** Global -- Closing link: Buffer allocation error -[]
- *** Notice -- *** TROUBLE: buffer allocation error! Increase BUFFERPOOL! ***

now i know u guys say to check the u lines however we are using the newer format as mentioned in the install document
the link section is as follows

                username                *;
                hostname      ;
                bind-ip                      *;
                port                          6667;
                hub                           *;
                password-connect  "Mypassword";
                password-recieve   "Mypassword";
                class                         servers;
set {timesynch {enables no; }; };

as mentioned if i don't assign a bot to a channell services run absolutly fine its only once this is done that it slows down disconnects and the service hangs ...

any help is apriciated.
Post by: ben on July 10, 2007, 08:20:13 PM
make sure the link block is right
and the services.conf is setup for your server <-- how do that right :[
Post by: Jobe on July 10, 2007, 08:54:12 PM
Most probably ulines if anything IRCd side.

If the link block was wrong services wouldnt connect to begin with.